Insulation and glazing of the loggia, in addition to the cherished extra meters of living space, will increase the temperature in winter by about two to three degrees. It would seem a little, but for the human body it is quite perceptible. A logical question arises: how and what is the best way to do this? First, let’s try to figure out the point — «what». A material called penofol is best suited. Thanks to the use of the latest technologies, it has very high thermal insulation properties. The surface of the foam is covered with a foil that reflects heat, thereby increasing the efficiency of the material. Small thickness saves space. For the second layer, you can use Penoplex. This is the most suitable tandem for the walls of your loggia. Also, do not forget to buy energy-saving lamps and install them in the loggia and living room..
Stone wool is suitable for floor insulation. Now it’s the turn of the «how». First, the floor is insulated. A vapor barrier is laid on a concrete screed, then a bar with a section of 50 * 50 and a distance of 50 cm from each other is sewn. Between them we lay stone wool, it is remarkably cut with an ordinary knife. We lay a rough floor on top of the timber, further actions depend on how the final floor is planned. Now the walls. Penofol is glued to the wall by the side, there is foil with the fire. The next layer is penoplex, then a wooden beam. To fasten the timber, use long self-tapping screws so that they can reach the wall through the foam layer. The material that is intended for the final finishing of the wall can be attached to the timber..
